BTW, the term is Cutter Radius (or Diameter) Compensation, or CRC.
The codes that control CRC are
G40 Cancel compensation
G41 Compensate Left (For climb cutting) <---- standard on CNCs
G42 Compensate Right (For conventional cutting) <---- standard on manuals
__________________
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |