Ok ... so I am getting to the point where I have to choose what motors should I use. I think that PlazPak-3 from candcnc.com is very nice .... but maybe I don't need that much. Maybe steppers are just fine. I don;t plan on doing anything with the router in the near future but it can be a posibility. Now I'm thingking - If I'll buy it - might as well but the most complete system - right? Now, are there any differences in the way of building the table if using the servos vs. steppers ?
Also, is this going to work with a servo :
http://www.modularcnc.com/linear_slides ?
I am still looking for linear slides (need 2x80" and 1x59") and rack and pinion combination for the 3 axis.
Any sugestion will be appreciated. Thank you