Yes, 5C to 6C should feed the Z axis. Unless someone has been playing with the wires. If I remember correctly, wires 11 and 12 are the X axis and are typically on the 5A and 6A terminals of T2.
The good thing about these machines is that you have 3 independent circuits that can be compared against each other for abnormalities. This is a great aid in trouble shooting. But if it is a instantaneous event that blows a transistor, it may be very difficult to find. Fortunately all of my customers are companies that do not use phase converters so I am spared the situation you are in.
George
__________________
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
|