Hu,
I just did another test with Planar finish to make sure that was ok also.
Planar finish feed at 15 : time 2 hours 29 minutes
same as above feed at 30 : time 1 hour 14 minutes
Just as it should be. About 1/2 the time by doubling the feed.
I don't know what to tell ya. You cuold e-mail me the file and I'll run it thru my system and see it it differs from your figures.
__________________
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |