just want to make sure someone isn't making with a chisel and rock. |
I gave up the rock. They chip too much and it's hard to get a consistant 'smack' on that chisel, (bad ball-screws I think). I switched over to an oak branch instead. More consistant and I have a good working post for it. 
'Rekd
__________________
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |