Hi,
My question was about wich system is most comfortable the SMC 1500 with PCNC or a ordinary direction and step system, it seems that the step and direction is the most common for hobby use.
I have the Conrad card without the step and direction option, it is cost effective to use this products for my new cnc machines and or should I go on with this card and buy the option for step and direction.
It also seems that it is a lot of DIY step and direction projects and much more software for this type of stepper drivers.
Can any explain the differens between the PCNC without step and direction and an ordinary step and direction product.
I will also mention yhat the Conrad SMC1500 with the PCNC SMC1500 software is very good and it also seems that it can drive any small stepper up to 1.5A wich can drive any good design.
My new CNC are equipped with pro linear rails so a small stepper motor should drive it easy. |