Originally Posted by moldcore  I do a lot of multiple surface machining and see this all the time. At first I was bothered by it but upon closer inspection I found that the area that appeared to be skipped over was actually within the specified scallop height. |
moldcore, you may want to take a even closer look the next time you see this. You just might end up being bothered by this as I am beginning to be.
I was able to determine that in the example I am showing in my original post. The scallop that SurfCAM is leaving using 3D PLANAR is .0018", I need .0001", I had the scallop height set to .0001" in SurfCam.