Ok here is my original thread >
http://www.cnczone.com/forums/showthread.php?t=37296
now..... I got a good idea of what I need to do as of making my Router Table. I was going to buy the $149 20mm Linear 55" Rail Guideway System ( would need two) but $300 bucks is alot for me at this moment... soo I am designing what I call my "bearing car". it is half inch aluminum plate by 6" L x 4" w and it will have 6 skate board bearings. what it will roll on: I'm thinking 1" square aluminum tube (x rail) yadda yadda yadda I'll figure the rest out.. now what I am wondering is..... when I figure out what motors and controller + software how will I calibrate it? or "tune" it?
I saw a couple links on Ebay of some what they looked like "RTR packeges" (3 stepper motors + controller + some thing else) those any good?
links to motors and controllers or packege deals will be appriciated!
-Dan