[sco999]

Hello,
I just purchased my first milltronics this week. It is a 1998 VM24 with the centurion 6 controller and has been upgraded with the High Speed package. It was also upgraded in dec of 2005 to the single board and has 64 mb of ram and 256mb compact flash for hard drive. It had a network connection on the board already and I had the machine dealers service guy install all the correct drivers, and he assured me it was connecting to his laptop before they delivered it to my shop.
Now I am in need of assistance on getting the machine to connect to my pc. I have a dedicated pc that I will be using for the milltronics with windows XP Pro on it. If someone could give me step by step instructions on setting the pc & the machine up I will be one happy camper. I imagine I would need to make a shared folder and then map it as a network drive or something of that nature. I am somewhat familiar with networking windows xp but have no dos experience.
My goal is to be able to load my programs via ethernet to the ram on the controller. My largest programs are about 50mb and I am going to upgrade the ram to at least 128mb.

Please someone help me!!!! I need to start cutting chips ASAP.