I thought I seen a thread on rebuilds but can't seem to find it again. Anyway, I posted more a more specific description of the task to the general machining forum as we might be still looking at Haas too (if they had re-builds, probably would be the choice as we get great service from them on our toolroom VMC), but there looks to be a lot of value in the Fadal remanufactured machines [sorry if this is a slight cross-post].
Like new, the salesman said "current controls, motors, yada, yada, six month warrenty, yada, yada"
Anything I'm missing or being mislead?
Any chance the factory would let me do a final run off before it ships, so I can have it set up for the specific application? Better yet, will they install custom aftermarket options? Will they put in a Fanuc control [I may be wrong, but think parts would be a bit easier; programming idiosyncracies should be closer to the HAAS too, perhaps] in the rebuilds? (the salesman didn't seem to know much about the last few questions)
Thanks!  |