Originally Posted by Madclicker  Using that motor on any DIY project z axis I've seen would be like dropping a big block in a riding mower.
I built a 60V supply from a microwave tranny. Had to guess at a voltage that would make all 3 motors happy. Works well. |
i think i see what you mean now, i looked at your build to check it out and noticed a large difference in the nema 42 and 34 ,but it didn t really kick in until i opened the parcel , this sucker is huge , far cry from the nema 23 motors i started with on a previous build
you obviously must be using limit switches ,cause i can see this tweaking a gantry if a guys not paying attention
getting back to the big block in a lawn tractor , fitted with a beer holder i'd be out cutting the grass far more often