I am currently getting 46 IPM with Turbocnc. That is the motors are not hooked to anything yet. I can make it go faster, around 55 IPM but I can stop the motor with my fingers then! Currently building a new machine now. I am hoping to get at least 35 IPM or more when the machine is done..
I have DESKNC the dos version but have not tried it yet. I heard it lacked some of the gcode that Turbocnc will do!? I tried KCAM but the stepper do not run good under windows. Too bad really. It seems like it would be a good product. Plus after looking at his site, he does'nt answer any questions on his forum. MEANING NOT VERY GOOD SUPPORT....
__________________
My little piece of the web!
http://users.adelphia.net/~wjdupont
|