Kenny, you're entirely welcome.
You'll prolly want to be fairly conservative on the speeds/feeds and angle of ramp at first, until you get used to it. You'll be able to go pretty fast, but it's a bit different than normal milling.
I used to drill pilot holes, but finally realized it was even faster than that.
'Rekd
__________________
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |