Call Milltronics and purchase newest version of software for your mill.
Then a polygon ID or OD is very simple without scaling.
program set up.
tool change.
"Mill"
"Frame" for OD
"Pocket" for ID
setup page describes location, depth and how many passes
describe part dimensions
end of program page
cut parts
make $$$$$
PS: What is your location to Minnesota?
I drove 1250 miles to the mill and lathe training class in 2004.I had been programming 7 different controls at ALCOA in G code. the conversational on my RH 30 is so far above and beyond anything you can do with G code that it will make your head spin. It was by far the best learning experience ever and worth 10 times what it cost. |