The syil x3 is completely out of the the maxnc 15 i have. There is no comparision. My maxnc was not accurate and broke down often when cutting aluminum. They are more suited to plastic and the software is dismal.
This machine is heavy duty, i did test cuts last night and was amazed at the night and day difference between my two machines. If anything the syil cuts much faster than i am used to. i slowed it down, based on past maxnc performance it didn't need to be slowed down. It sliced through brass and aluminum like butter.
Mach 3 is an amazing program, i wonder if the performance of my maxnc would improve if i ran it on mach 3...even so they just aren't powerful enough to compete with this machine.
Again i cannot express the value of the customer service these guys provide. Richard (thanks Richard)spend 2 hours with on the phone after hours helping me set my machine up. Sacrificing quality family time to help a customer as dumb as me goes a long way in my book.
I will continue to buy products from these guys because i like how they run their company. I cannot give this machine or these guys a high enough grade, i am very very pleased.
Derek aka Legion
Last edited by Legion99999; 01-16-2007 at 03:26 PM.
Reason: typo
|