[thuffner3]

Thanks for the info Guys,
I like the way your thinking High Seas, in regards to a basic intergration break down. I think that would be so helpful. And save alot of double questions. It's so hard for a newbie to wollow through all the possiblities. Man, I'm still wollowing. But at least my machine is working. I'm loosing steps somewhere, but it is getting better.
I believe somewhere at about 2500 linear inches of travel along the x axis my machine looses about an 1/8" 0r .125", then it dramtically increases from there to about 1/4" or .25". I think this has alot to do with my settings in TurboCNC.