Folks - We have CamWorks and was curious if anyone is using it by working from an assembly. We also have SolidWorks 2006
My assembly consist of VF4 Haas table 18" x 48" with two kurt D675 vises.
By taking one part at a time placing them in the assembly, how would CamWorks or should I say how would I set-up CamWorks to recognize multi "Z" locations.
We do not have a rotary table so once one side is machined it is removed and the other side is machined in the next vise.
I might be asking alot from the software. We just piece the code together by hand (cut and paste) for now.
Any thoughts would be appreciated!!
Great Forum!
Last edited by pnance; 01-08-2007 at 06:25 AM.
Reason: Added Picture
|