There are a number of people on here that have used them, and I know that the owner of Torchmate comes on here often.
Look through all the forums in the cncplasma forum, I know there are a few here.
You can also check the Flashcutcnc forum on here, as that is the software Torchmate uses.
Hope this helps, for what it's worth.
__________________
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
"If the women don't find you handsome, they should at least find you handy"
-RedGreen show. |