Originally Posted by Foils  I am using the same HCNC board at 12V and can get a consistent 6mm/sec driving an M6 threaded rod without missing any steps. Startup and slowdown velocity ramping helps too, going from 0 - 6mm/sec instantly is a bit of a tough call for any motor! Depends on the software your using whether or not this functionality is availiable. |
Are you running with the ramping on HCNC or is that on some other software?
I will be trying to get some RENE wire soon to give that a try, The kerf is very wide with the ss fishing leader .
rick