I built the Sosylva 25x37 table. I was a complete newbie (am a little better now) when I started and I must say the instructions were simple and to the T. I did not have any problems. Each part is layed out step by step with many pictures. Don't know how the manual could be any easier and again, I didn't know anything. Takes a little while but if you take it one step at a time, it finally all comes together. Mine is very slow but is precise. Again, it being slow is probably because I don't know enough to get the speed out of it. I think this is a good machine to start with. I have not had it very long and already looking to build a larger and faster machine. |