[TCSpooner]

Hi

I'm trying to mill a foam plug for a wood burning stove top casting. I have tried to mill a smaller model on two other machines each time I have had the same problem. I am using the Mach2 post processor supplied by sprut. I will try the Tormach post processor and see if it improves things. I also downloaded and tried NCplot I showed some stepover but I must admit I am not familiar with the fine details of using NCplot. Which means I don't really know what to look for. I'm not really concerned about the ridges left by the milling at this point I would like to sort the step over problem first.