Hello!
I have a couple of higher voltage DC brush servo motors and am thinking about purchasing the R90H drive.
My questions:
How hard is it to tune this drive for a motor? I'd like to use it to test a few motors on and am wondering if this will be a pain.
200 volts at 40 amps seems like quite a bit of power to pass through something so small. Would it really be possible to run a 200 volt motor at 40 amps continuously on this drive? (I won't be using that much power - but it would be nice to know)
This drive will need a pretty large heatsink (?) - wouldn't this make it pretty hard to use it with their motherboard?
Any input will be greatly appreciated! Thanks! |