Badrandle at this time master came does not sgip with a Mplhaas.pst but to get close start out with the MPLfan.pst post this is the Fanuc post that is the default from the install.
I have allso checked my install of MC 9.1 release and still no standerd Haas post.
Have you tried speaking with your local dealer they should be able to take care of this with most likly no cost to you.
__________________
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Mastercam Instructor , Programming Consultant and ME (Manufacturing Eng) |