Hi again Scott,
I was wondering if it would be possible to somehow have an option in NCPlot to do some basic checks on the program like if a feed move has been programmed without a feedrate or is the spindle on when feed moves.
This has come to mind as we have recently had a BUMP on one of our m/c's due to a few different programs being pasted together and a feed in mm/min was encountered while the spindle was not running.Although feed in mm/min is accepted as being fine, in this particular case the spindle should have been on. If we run the prog through NCPlot it could maybe give a list of potential mistakes like this.
Thanks Turner |