Originally posted by inthedark
Can anyone recommend a book that will give the formulas for metal bending?
For instance if I had .125 material and was going to put two .25 radius, 45 degree bends how much longer would my piece need to be to make up for those bends?
Does that make sense?
Thanks,
Kenny |
Have a look at this
'Rekd
__________________
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |