Not exactly sure what you're doing. I take it using the Studio in Mastercam with solids/surfaces to create a grafix image? If so, you'll want to use Save BMP to get it to your hard disk, then mail that. If not, explain a bit more what you're up to and we'll 'hook you up' ! 
Welcome to the Zone!
'Rekd
__________________
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |