Devinchi
If my shoptask tool holder is the same as yours then you have a main tool post with four vertical channels, one on each face of the post. The holder rides up and down in that channel and has a lip on top protruding over the post through which the adjustment screw is located.
What HuFlungDung suggests makes good sense....to take some of the bottom of that lip off.
Also, you could mill down a portion of the post on each face where that lip rests when the tool holder is all the way down. This may be easier as the post is already mounted and secure.
My QC holders are so very close to being bottomed out....but not quite.
Last edited by Bloy2004; 01-08-2004 at 03:19 PM.
|