Thanks Toby and Justin,
I think the feel is the goal. Justin I have tried a two flute 3/4 climb mill and it was good. Do I run this at 1700 or 4200 rpm? Thanks for the handle turn info which seems confusing when I read books and charts that say 600SFM. If i'm practicing on the end 1/2 " 6016 x 1 1/2" am I going to make this pass say counting thousand one, thousand two etc., up to three or six or ten? My point is I just don't know how to gauge what is a slow or fast feed. I'll look up chip load .
I truly appreciate the replys.
Thanks
Greg
(aka: no priors) |