Guys, guys, guys...
Why is it so difficult to get a Fanuc control to accurately feed on contours?
ref.
nocamhere:
g05.1
hardmill:
On a 16m you call g05 p10000- (on) and g05 p0 (off).
There are no canned cycles as well as many other functions not avail. when its(g05) active.
????
Hpcc (high precision contour control)
AICC (Artificial Intellegent Contouring Control)
That's my own name for that one... Cause it is "Artifically Intelligent" (good only for linear motion, NO circular interpolation allowed).
nocamhere:
I've been reading the manual that came with the machine, but i'm a bit confused at the difference between the HSM mode and the Hpcc. I know the Hpcc will clamp the feedrate around arcs based on the max allowable error, but that doesn't seem to be all that fast. correct me if i'm wrong, but the HSM mode will look ahead a bunch of blocks while the Hpcc will look ahead only 1 or 2 blocks to clamp the arc feedrates...right?
WOW, Can Fanuc make it any easier for a guy to get confussed?
I suppose they could, but then they'd be too much like Fadal...
In pursuit of good motion control,
Scott_bob
__________________
Scott_bob |