Originally Posted by RadekCX Alan - I send to your mailbox (before I posted message in this forum) two e-mails - first 12/13/2005. Here I writed about my version PICstep and you can download my FW with torque compensation.
Before many weeks I write second email - here I write about the bug in our FW.
On my emails you do not replied. Maybe in this time was possibly cooperation.
Then I posted message in this forum. Alan don't cry now! |
I receive nearly 600 emails everyday, I do not reply to everyone because I wouldn't get anything else done. Also if the english is particularly hard to comprehend I'm even less likely to respond.
As for crying, I've done nothing of the sorts other than trying to decifer what you are talking about and trying to reduce your bad mouthing of _my_ many months of work.
I think you are misunderstanding my responses as aggressive when all I'm trying to do is figure out what it is you have found. Yes I understand you have produced a commercial driver, but using my driver and it's "buggy" firmware as a reason to purchase yours isn't very friendly.
Originally Posted by RadekCX How community "helped" produce my version FW!!!?? Schematic PICstep is identicaly with recommended schematic in DS LMD18245. Is it not new. New my FW is absolutely different. |
The fact you even stated you got your ideas from my driver is a prime example. I think the language barrier here is proving to be the biggest bug in this dialog. I doubt I could understand the issue you have found even if you put it as simply as possible. I get it has something to do with the datasheet information for the LMD about coil current control but what the bug is I am still scratching to understand.
Originally Posted by RadekCX Driver Bistep now completed company not dependent on me and I cannot FW release.
I have not obligation to community!! Information about bug you know now. It's all. |
Nice, good fortune to you too.
Alan.