Hello people,
after reading the forum almost every day i got hooked up.
First i was looking at a cnc ready benchtop mill.
the objective was to semi-design a high-end 1/10 rc car ( 0-90, under 3 sec. over 60mph top and racetrack handeling ) and than mill it at home.
now the problem is that the cnc virus got me
so now the objective is to make a small high-end (6mm end mill max. )
vmc
this has to be done before i have my degree in automotive engineering.
if this virus doesn`t come to a stop, the deadline will be the year 2047
just joking, ...................... 2009
remember a student isn`t the man with money, so this is a DESIGN thread, yes i`m working my ass of for the money. A nice machine will cost a couple off dollars. (euro`s)
the goal for this thread is to show the design off my machine, i hope you guys cann help me with some questions i have.
it would be great to let the expert with hands on experience shine there light without taking it to far.
i hope to give a few good questions with examples off some problems.
maybe it will help every one that needs it.
kind regards,
Roy Bakker
the Netherlands.