Originally posted by HomeCNC
Making a servo controller box is not that cheap! Be careful about this. Look at my website, I have a picture of a servo controller box that I built for someone on the Zone. It was about $800 just for all the parts. Geckos were part of that cost. |
OUCH!!! I guess I'm a bit naive about the cost of this. I'm looking at the box you built. I see a torroid, cap, 3 gecko's, and another board hooked to the gecko's. What is that board? A break-out? I'm still learning. I can't be spending $800 on a servo control box.
