Originally posted by balsaman
I think Jeff (HomeCnc) had some nice servo's with encoders for $75.00 each in the for sale forum.
Turbocnc will run your servo's fine at $20.00 to register. |
That sounds perfect. I'll look into that. Turbocnc sounds perfect. I'm trying to get it working for as little money as possible but don't want to skimp... probalby what 90% of the people are doing I suppose
I'll check those out.
[EDIT]
Just checked them out and think I'm going to buy three. Which acme thread pitch would you recommend with those motors? 10 tpi?
Thanks again.
Darren