the basic math is simple:
Power = 2*Pi*N*T where
Pi=3.141592654....
N=speed (usually RPM)
T=torque (N-m, oz-in, or ft.-lb.)
You'll just have to keep an eye on units to make sure they cancel out properly. I'll be back and post my calcs in a bit.
__________________
My name is Electric Nachos. Sorry to impose, but I am the ocean.
http://www.bryanpryor.com
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Last edited by NeoMoses; 12-13-2003 at 02:09 PM.
|