Jerry,
I had not realized they were a stepper motor system. We cannot work with stepper motors, (most mainstream control manufacturers cannot nowadays)
You may want to contact Gecko and simply advise them that "the control manufacturer provides a +/- 10vdc command signal to the servo drive and accepts standard quad 5v TTL encoder feedback for position."(We also accept 1vpp)
These are pretty much the industry standards and definitely the most common, and they should know exactly what you need based upon you telling them this. I personally would hate to give you advise on which Gecko drive/motor combination without a thorough Gecko product knowledge. I did go to their website, but its sluggish right now, had a hard time bringing up any pages on it. I would also encourage you to re-open a dialogue with Mohit at the Canadian office. He has a thorough understanding of everything we are speaking of within this thread and he is one of our top Engineers here in North America.
Darebee,
Thank you for the kind words, and we are happy to hear you are having success with your Fagor control !! Call us if ever need any further assistance.
Todd  |