Check your email, Mark. I'm not sure if there is any reason why they wouldn't post the link here, except maybe they are too busy to do it. So, until I know otherwise, I'll send it by email or PM to interested parties.
EDIT Upon closer examination of what the installer does, it seems to change Mill Professional into a OnecncXP Mill Professional, but then it requests a new password for it as well. So a word of caution, don't install this over top of your existing Mill Professional until we find out what is supposed to be happening.
second edit
Michael Reyes at Onecnc cleared up what this new "3 in 1" patch does:
Murray,
These are XP Series Products not 2000 Series and you have every feature of both production and professional in the Expert system and have no need for the other two. They are basically the same programs with selected features turned off.
Michael |