Originally posted by fjd
The way i read what u have from Z zero you would have drilled
1.95 deep |
Note the G90 in the MAIN program and the G91 in the SUB program. So is it reading the R-.9 then taking the Z-1.05 from R-.9?
WMS, this is what I thought also. But according to the (thank god) Z over travel alarm I recieve just above the part, it doesn't.
The max travel on the Z is almost 3/4" BELOW the top of my part, the tool is set to the top of the part, (.04" thick part)
'Rekd