Sweet......
You were right, Paul, somehow the driver never got loaded (but I sure did). I tried to reload according to the instructions several times, and finally I got it. The test runs succesfully, although the scan line has a lot of spikes in it. Nevertheless, it chugs along and then says "test succesfull", so I imagine I'm in the ballpark. I should have time this weekend to attach to some hardware, I'm looking forward to it, providing it works, of course
Are the glitches in the scan line a bad indication of some type? Is it supposed to be real smooth? (my other computer shows a line thats smoother, like the one in the manual)
__________________
Halfnutz
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
|