NCPlot is a great programm. But i missed something. Wish there was a page where i can set the axis number. Like X is 1, Z is 2, Y is 3 or something because in my macroprogramms i work sometimes with machine positions. Like #5001, #5021, #5041. You have writen me that some of the machine position parameters were in NCPlot. But i am to
*lol* If you can make it that the parameters would work then NCPlot is my first choice. Hope you can understand what i mean.
Example:
X-Axis = first axis
Z-Axis = second axis
%
:1234
N1 G0 X250.0 Z250.0
N2 T0101
N3 G0 X100.0 Z0.0
.
and so on
Bevor i start the programm the machine positions are X150.0 Z100.0
In Line N1 #5001 should be 250.0 , #5041 should be the actuall position (150.0) and #5021 the distance from refpoint. #5002 should be 250.0 and #5041 should be 100.0
Can you implent this in NCPlot? Another question. Can you make it that NCPlot can preread a setable number of blocks? That would be very interesting by use of #504....
Markus