Mach2 motor tuning problem??? | |
I tuned my motors and with discrete jogging, its right on. I tell it to move 100 thou, it move 100 thou and so on. Put the dial indicator to it and its great.
However, when I run G-code programs, the scale is off...
For example, if I try:
G00 X0 Y0
G01 X1.5
It doesn't go to X of +1.5, it goes to X of +2... but the DRO says its at +1.5.
Ok, this has me baffled... did I miss something in the documentation here? |