Originally Posted by Zumba Thanks for the replies.
The websites that sell the mag drills say it's for 1/2" steel or thicker, but apparently 1/4" is just fine? |
The problem with most of them, is that they were made for large diameter drilling. That puts the RPMs below 600, with an average of 450RPM.
Milwaukee does have a base, but that alone is around $900. The drill motor would add another $300-$500 from them. You could mount your own with a higher RPM, I suppose. Not very effective for anything less than a 1/2" bit.
Milwaukee Base
This is more like it, but no price listed.
Comeq M-100D
DC