[AMCjeepCJ]

Hey everybody,

Tim Horgan from Milltronics just contacted me and he has fixed the software bugs I mentioned! Talk about quick response! They are fixing the autoload parameters on start-up thing in the next release but he sent me a file to install on my machine to fix the 'remove tool lengths' graphics error.

If you have or had trouble with your door pinching your fingers, put a small magnet there and you'll never have another problem again, not to mention you can pop them off when you need the extra two inches to load a part on the table.

My apologies go out to the milltronics person, (you know who you are,) whom I quoted from an email. I now understand more fully why you said what you did and I appreciate your honesty in explaining your position without giving excuses. I really like the integrity of the guys and girls at Milltronics. Every one of us makes mistakes but it takes a quality individual to take criticism without putting the blame on others. I've noticed more integrity in dealing with this company than with any other customer or vendor I've ever dealt with.

I'd welcome any of you milltronics guys to share a little about the company on here and what your mission is now and in the future. In my book, it's a clean slate. Yes, in the past we bought a junky mill from you guys in the early 90's but I am so thankful I talked my pop into buying this mill from you guys and giving you the benefit of the doubt. We honestly thought it was a gamble but it was a gamble that is paying itself back EVERY SINGLE DAY!

Thanks Tim, Benji, everybody...

You and your products are great~

Sincerely,

Carl P. Stender