Yes, there are two concurrent F1's in the first section of code alone, and several more down the line.
Here's the first basic section:
G90G80G49
G0 Z1.0000
G90.1
S1000
G0 Z1.0000
G0 X-97.0000 Y29.8333
M3
F1.000G1 Z0.0000
F1.000G1 X-97.0000 Y42.8333
G1 X-97.0000 Y43.5000
G1 X-97.0000 Y44.1667
G1 X-97.0000 Y44.8333
G1 X-96.8333 Y45.6667
G1 X-96.6667 Y46.3333
G1 X-96.5000 Y47.0000
G1 X-96.1667 Y47.5000
G1 X-96.0000 Y48.1667
G1 X-95.6667 Y48.8333
You can see I'm a total newb and am relying enirely on the conferters at this point because I won'tknow what I'm looking at until I learn a bit about the G-Code itself.
I don't even think I know enough to ask intelligent questions. Here's a question: If I change that F1 to something like F40, will that change the feedrate to 40? |