Hi Huflungdung and WMS!
Thanks for taking the time to reply.
If you see my 2nd post, you'll see that cancelling the tool offset (G40?) seems to do nothing.
The Software limits are as they have always been.
Depending on the move (direction) the S/Ware O/T may not necessarily operate, but position seems wrong.
The main point seems to be the G40 ? (see L959 Listing and my 'manual data input' code)
I can clear the offset by programming D0 in the move block, but this was never in the original code?
Have a nice day!
Richard. |