I'm working on a surfaced part program using Mill Professional, the part is very similar to a piece of crown molding stretched to 21" wide by 90" long. The roughing passes (3/4" rougher bit) are a breeze along with the gentle flowing curves (1" ball mill), but I'm trying to sharpen a negative "crease" line by using a "V-groove or sign making " bit with either a 60 or 82.5 degree grinds. Is it possible to load this tool info into OneCNC (Custom Tool) so that I can use the "cut model" command to clean up after the ball mill while avoiding any gouges? |