[George]

Ok, I now bought 3 nema23 300 oz/in dual shaft servo's. To run them for the momemt I have bought a Delagrange stepper controller. This controller will drive 4 axis at 10 amps per axis so that should be fine.

I would appreciate some help on the ball screws for all 3 axis. There is so much information that things begine to get unclear.

My mill is the Eagle 25/ much like the RF25. It's screws are imperial/inches.

What advice can anyone give for ball screws. Cost & where to buy/simple to install and easy to work with are probably the 3 main things that come to mind in that order.

Any help would be very much appreciated.


Encoders would be my final addition so a good source would be welcome.

Happy Christmas to all....

George