Originally posted by HomeCNC
Can you machine the extra barbs off using a lathe? |
Yes, I suppose I could machine them if I had a lathe, but unfortuantely I don't. Also, that would be very time consuming, and difficult to justify vs. the current cost of less than $0.50/barb. I believe these
should be manufactured by somebody in the US, I just need to find them.
I've been looking around @ thomas register, but no luck yet.
Here's a look at the difference b/n single barbed and multi-barbed fittings. FYI, I'm looking for the single barbed fittings because they tend to seal better.
Single Barbed Hose Barb w/ Male Pipe Threads: