HU,
I don't know if what you are asking for is possible.
Do to the fact that the program for safty reasons only makes rapid moves at clearance. And I can say I under stand why.
Thats not to say that I don't agree that it would be nice to do it exactly the way you are suggesting. I think that to error on the safe side is probably the way to go.
I have myself made the mistake of tweaking code only to find that now the tool goes thru the part instead of around the part. Not good.
__________________
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |