O/T Mouse Settings.."Snap To" | |
Is there a way of getting straight to the SNAP TO toggle of the mouse/pointer options? I love having it on about 50% of the time, and HATE it the other 55%. When in Mastercam, I want to be able to toggle it on and off without having to open mouse properties, click the right tab, then click the toggle button.
I'm pretty sure that data is stored in the registry, but don't know where. If it IS there, I can write 2 reg files that will toggle it, then run those files from my quick launch.
Is this AT ALL possible? Or am I all wet?
TYIA
'Rekd
__________________
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |