I've looked at hole popping, they don't get big enough. Looks like gun drilling will be the ticket. It's a manifold, so a mismatch at the intersection is ok. (Drilling from each end is ok'd on the print, along with mismatch)
I found another print with a .166 hole 15" deep, ********.
'Rekd
__________________
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |